SPRINKLERS
Please remember that this equipment is not cheap. If you aren't sure how to do it just ask.
If you happen to break something please let us know. Please do not deviate from the instructions. If equipment is being found broken on a regular basis we won't be able to continue to allow it's use.
VIDEOS COMING SOON
​
QUICK CONNECT FITTINGS: Please do not twist them. Always make sure both ends are completely clean or it will damage the fitting.
If there is a quick connect fitting on the hose:
To disconnect: pull the large ring away from the smaller ring and pull apart.
To connect: pull the large ring and place the clean fitting end into and push, the large ring should snap back.
OUTDOOR ARENA
New system, uses 2 tripod sprinklers to reach entire arena
2 important things to remember:
1- DO NOT plug the booster pump in till both valves are open
2- Be sure the hose is disconnected from the sprinkler whenever you move the sprinklers
Steps:
1. Go in well house, open valve on blue hose going into booster pump
2. Open valve on green hose going out of top of booster pump
3. Plug booster pump into outlet
4. Close well house door go into arena
5. Place sprinklers in the arena
I'll be marking the fence soon but basically place each sprinkler in the center of one quarter of the arena.
6. Connect the hoses to the sprinkler, they have quick connect ends (pull the large ring back and place the clean end in and push. The large ring should snap forward making the connection)
7. There is a brass 4 valve fitting along the fence, open both valves that have hoses connected.
8. Once each section is watered, turn off the valves on the brass fitting, disconnect the hoses from the sprinkler and move the sprinklers to the next section. Then turn the valves back on.
9. Once the arena is watered: disconnect the hoses from the sprinklers and move them both back to the grass on the side of the arena.
10. Unplug the booster pump, and shut both valves off (green hose and blue hose) Be sure to close the well house door.
INDOOR ARENA
​
1. Set tripod in center of half of the arena
2. Roll hose cart to one of the long rail gates
3. Roll out hose and connect to sprinkler, they have quick connect fittings
4. Extend the barn hose and connect it to the inlet on the hose reel.
5. Turn on the hose, then turn on the valve on the end of the hose connected to the inlet on the reel
6. It takes about 30 min of watering each half to completely water the arena.